1997 V6 - Recently I had my AC clutch start shaving metal. It was working though. I disconnected the plug and swapped out the clutch and its parts with new. I then put it all back to gether. Fired it up and clutch will not kick in. I tested all the fuses and relays and all is good. however I still do not get power to the AC clutch. Could it be a bad HI or LOW sensor? I only see 1 sensor and it has 3 wires and it appears to be on the HI side. Any help?

 

Only one sensor on these models. May be a bad cluch, have you tried feeding power directly from the battery to the cluch? Use a fused jumper to prevent fire. Also check grounding, there should be a black wire going to ground.