Cold Air Intake?
#11
Join Date: Nov 2007
Location: Eastern PA,
Posts: 10,362
My Ebay (China made) special
As shipped
Half way in
Done! Well except for supports and mods I am going to do.
You have to change the filter from underneath. That is the bottom lip of the driver fender
As shipped
Half way in
Done! Well except for supports and mods I am going to do.
You have to change the filter from underneath. That is the bottom lip of the driver fender
#12
Now I think that looks nicer than the K&N, but I like shiny stuff!
Is the tube plastic or metal/aluminum?
The only thing it doesn't have that K&N does is a block off piece for where it goes through the inner fender.
A roll of duct tape would take care of that.
Is the tube plastic or metal/aluminum?
The only thing it doesn't have that K&N does is a block off piece for where it goes through the inner fender.
A roll of duct tape would take care of that.
#15
Join Date: Nov 2007
Location: Eastern PA,
Posts: 10,362
Both the blue and black elbow are rubber. The chrome parts are metal. Seems like it would be pretty simple to change this to a ram air system. I plan cutting up some 1/8" thick carbon fiber sheets to clean up where the tube leaves the engine comparment.
#17
Join Date: Nov 2007
Location: Eastern PA,
Posts: 10,362
The kit came with a couple of light brackets. I assume this kit fits other cars cause I could not see away to use them.
I got it for 45 buck and free shipping,
http://cgi.ebay.com/ebaymotors/95-96...d=p3911.c0.m14
Last edited by Gorn; 08-15-2009 at 07:38 PM.
Thread
Thread Starter
Forum
Replies
Last Post
crimson09
Intake, Headers, and Exhaust
5
12-15-2018 07:07 AM