My 95 Camaro 3.4 Build Thread!
Thread Starter
|
2nd Gear member
Joined: May 2009
Posts: 528
The start of progress!
Well, the floor is almost done! It'll be completed tomorrow. Lots of cutting, and grinding and welding! If time permits, I'll drop the tranny. Jason has been doing the welding. Hopefully I'll get my welding course soon!
Here are a few shots of the auto club I'm a member of where I do all my work!
Well, the floor is almost done! It'll be completed tomorrow. Lots of cutting, and grinding and welding! If time permits, I'll drop the tranny. Jason has been doing the welding. Hopefully I'll get my welding course soon!
Here are a few shots of the auto club I'm a member of where I do all my work!
Thread Starter
|
2nd Gear member
Joined: May 2009
Posts: 528
Thanks for the nice comments guys!
Big plans this week!
- Removing the upper part of the engine. Upper-intake, lower-intake, valve covers, fuel injectors, TPS sensor, coil packs, and IAC motor!
I'm getting the gasket set this week for the upper, lower intake and valve covers! And I'm getting new O-Rings for the fuel injectors!
- I'm getting the 1-piece driveshaft too. I want to put that in with the tranny!
The lower intake manifold will have a date with the sandblaster and get ported and polished as well! The upper-intake is being replaced for the new chrome one and the throttlebody too! I'll also be doing the coolant bypass so coolant won't be going through the throttlebody anymore either! I'm putting in a new e-brake cable, and a fuel line that is getting bad that I saw when I was under the car.
I'll be doing the rear-end in April and putting in new shoes and drums in the back as well.
Right now, the fuel injectors, PCV, IAC motor and TPS sensor have been sitting in a can with pure Seafoam for the past week! It'll all be clean nicely!
Big plans this week!
- Removing the upper part of the engine. Upper-intake, lower-intake, valve covers, fuel injectors, TPS sensor, coil packs, and IAC motor!
I'm getting the gasket set this week for the upper, lower intake and valve covers! And I'm getting new O-Rings for the fuel injectors!
- I'm getting the 1-piece driveshaft too. I want to put that in with the tranny!
The lower intake manifold will have a date with the sandblaster and get ported and polished as well! The upper-intake is being replaced for the new chrome one and the throttlebody too! I'll also be doing the coolant bypass so coolant won't be going through the throttlebody anymore either! I'm putting in a new e-brake cable, and a fuel line that is getting bad that I saw when I was under the car.
I'll be doing the rear-end in April and putting in new shoes and drums in the back as well.
Right now, the fuel injectors, PCV, IAC motor and TPS sensor have been sitting in a can with pure Seafoam for the past week! It'll all be clean nicely!
