I got this off of a buddy of mine that was the manager for an auto parts store. It has no holes cut into it and it is hollow. so i was thinking about cutting out the wide end to fit my throttle body then running that directy to the existing 3 inch pipe with K&N cone filter (located outside the engine bay true cold air/ram air induction) any advice? what would i use to seal around where im sticking the throttle body into it? Any kind of like high temp sealant? Im sure it wont add much if any horsepower but Im sure it will clean up the engine bay and give a more direct flow. Thanks guys


[IMG]local://upfiles/4475/DAB55EA85D254EB4B3D9B068C366AE26.jpg[/IMG]