I need to change my two front turn signals. Can anyone tell me how to do this or point in to a site that has the instructions? Every place I bring it to says they can't do it so I figure I might try doing. Thanks.

 

WOW!!! i changed my corner lights to clears. It's a pain in the ***, but it can be done. Underneath you're car you need to disassemble all the plactic guards underneath. Then reach up and take it. It sounds easy, but there a lot of screws. Just jack the front up alil bit to get room and go for it. It just takes time and patience. I think there are 3 pieces underneath you take off each side, thre are 3 screws i think to take the lense out and change the light. good luck!!

 

Ouch. Sounds like fun. Thanks for the tip.

 

Be sure to check your blinker fluid levels for good measure! ;-)

 

LMFAO!!! that's funny and some ppl even fall for it!

 

Wow. No way I'm falling for that one. But I'll use it on other people though.

 

Woahhh... I wouldnt go into removing all the plastic from the bottom... did that once n its a pain... its much easier to remove the headlights... Just take the two nuts off of each headlight, wiggle them around a little bit and they r out... then the turn signals r right below there... very easy to get to for either replacing bulbs or replacing lenses