I pulled my steering box out to clean it, and would like to rebuild it before putting it back in. I have checked a few websites, but they only sell new or rebuilt units. (Manual gearbox in a '68)

Does anyone know where to get a rebuild kit?

Also, how do I pull out the main shaft (the one attached to the steering column)

Mine is so gummed up that I can't tell if it is the 1 1/4" nut or the 4-inch locknut

 

here is just a few I found in 15 seconds. I never opened any of the sites. they do say kits
Steering Box Rebuild Kit - Superior Quality Steering Gears‎
Camaro Manual steering rebuild kit 1967-1968-1969 - Heartbeat
Camaro Steering Box Parts For 1967-2014 Camaro From Ricks
Steering Box Rebuild Kit | eBay
this mat also help
Anyone ever rebuild their manual steering box? - Team Camaro

 

Thanks, I never searched for it, just went to my known parts sites. Someday I'll figure out this internet thing!

 

Ended up going through Eckler's for the parts. They had the input and output seals, and the gasket for the access plate. They didn't have the brass sleeve/bushing for the output shaft, which was actually quite worn.
Judging from the condition of the lube, which almost looked like bearing grease, this part hadn't been touched since new!

 

Hi Robert. Try places like Summit Racing for parts like this. (They will send you a free catalog too.) Great selection, knowledgeable people, and tough to beat their prices. I like Eckler's and have ordered plenty of stuff from them, but for parts like this, go with a place like Summit and save some money.