i have this 1988 chevy camaro 305tpi. well i took out the 305 and put in a 350tpi do u think i should change out computers. that i should find one that was made for the 350tpi? if so wut else do u think i need to change as in sensors, ect......


thanks

I would say yes, I would be suprised the car would even run, the fuel and timing maps are way differant on a 350 than a 305

yea definitly change the computer, if it in fact is a real 350 TPI

alrighty thank you

local://upfiles/911/6327B40DD3394D3CA71147834F9E639C.jpg

here another one

local://upfiles/911/07993D9208DB4F149C4F02FCD6EF005F.jpg

Good looking 3rd gen you have.

i have another question for ya? so i took the computer out. shoild i flash it or should i try to find a new one for the 350 tpi or tru to chip it? and wut else to u think i need to change on it......like fuel pump sensors ect........?

local://upfiles/911/B2049D7AE7904FAB8F475D507C71AA8F.jpg

ORIGINAL: rm82folife

i have another question for ya? so i took the computer out. shoild i flash it or should i try to find a new one for the 350 tpi or tru to chip it? and wut else to u think i need to change on it......like fuel pump sensors ect........?

local://upfiles/911/B2049D7AE7904FAB8F475D507C71AA8F.jpg

The 350 computor should be fine uless you do alot of mods, such as, a cam change or head work. If you want to put a chip in it, wait till you do all of your mods then get the chip. Sensors should all be the same, as long as you stay with TPI, both motors are TPI right?

yea wverything is same with the tpi i just switched block to 350tpi

local://upfiles/911/84B89C749E2A4005BEE524C39AF8FCDB.jpg