One of my sons friends runs a little S-10 with a 350/7004r setup.

He had a lot in the motor...was running N2O....Not sure which system...

Guess he ran a little to much....[]

ooppps......

Damages trashed 2 pistons, 2 rods,block,cam, one head (camel hump angle plug),etc

Was a fast little thing...

Another "I didn't plan well example"...was using hyper pistons instead of forged..another $200 spent in the beginning and he may have been able to avoid a $2500 replacement motor...

G.




[IMG]local://upfiles/5756/E7EC1DA04597402AB938DF2A4D9C1A11.jpg[/IMG]

 

Thats more then a oops thats more like an ouch, dam!

 

i thought about doing that before i bought my camaro but im more of a car guy. sounds badass thobut right now id hate 2 be him

 

Hey, look at it this way, he gets to try and learn what a slip sleeve is. lol

 

Unfortunately the lower part of the cylinder has a crack from the water jacket into the main area. No sleeve for this one....

He found a 400 truck block and crank....so we will see where he goes with it...

He's bringing his heads over today so we can drill the steam holes...

He's gota pretty good job doing landscaping so I figure he's going to build the hell out of it...

Told him he need to get a rear end that would handle it...

Oh well we shall see...

G

G

 

Keep us posted on his build, tell him to join and post some pic's...........That must suck havin that happin.