blew my head gasket changing them myslef and it is not fun at all it really sucks any info to make it easier it would be great

 

Get the heads resurfaced, otherwise you will be doing the gasket job again in the near future.

 

just reading you rpost I get a sence of a beaten, exhausted man albeit slightly tipsy and extremely frustrated with the task at hand.

What do you have in the way of shop literature?

 

the heads may or may not need to be resurfaced but its a good possibility,especially with aluminum heads.they should be checked with a straight edge to make sure there isnt any warping present.and if they have to be resurfaced, if there is more than ten thousandths of an inch taken off the heads, the intake manifold will need to be matched

 

thanks for the info and every thing checked out ok and I should be done with it tomarrow just need to figure out where a couple of thing go and that is it then im getting it ready for spring and new paint

 

it is together now and it is running fine took forever to get it done to long