Any ideas on where to get a set of headers for a gen 3 ( 1988) camaro with a 454 big block? Iron manifolds are quiet thats for sure but on a big block I think ya have to have headers just to get what you set out to do!
thanks
scott caldwell
scald50@aol.com

 

you should probally check out getting them made for you, it will be pricy but worth it. You could look for low profile BB headers. They wont pe specific to your car since no BB were offered in the 80's

 

This is about the only ones made for a BB 3rd gen. Get the heat rap tape as well. Hooker super comp part # 520-2226 at jegs

http://www.jegs.com/webapp/wcs/store...chItemId=26567