how to bypass express down module?
Thread Starter
|
1st Gear Member
Joined: Jan 2013
Posts: 209
From: Florida
how to bypass express down module?
Does anyone know how to bypass the express down module if it is possible?
I cannot find a module anywhere locally as far as junk yards go. I heard that you can bypass this module by splicing some wires? ANY help would be excellent. Thanks
I cannot find a module anywhere locally as far as junk yards go. I heard that you can bypass this module by splicing some wires? ANY help would be excellent. Thanks
Fourth Generation Moderator
October 2009 ROTM
October 2009 ROTM
iTrader: (1)
Joined: Nov 2007
Posts: 10,560
From: Eastern PA,
ROTM Winner's Club
2nd Gear member
Joined: Aug 2013
Posts: 509
1. Unplug and remove the Express Down module, mounted to center of the dash mat above the floor tunnel. Place a tag/label on the connector for the express down module: "Do not install unless jumper inside driver-side door is removed."
2. Inside the door, jumper the gray wire at the window switch to the brown wire at the window motor. Put a tag on the jumper stating it's purpose.
2. Inside the door, jumper the gray wire at the window switch to the brown wire at the window motor. Put a tag on the jumper stating it's purpose.
2nd Gear member
Joined: Aug 2013
Posts: 509
Other modules, if installed, are in the general same area. Just to make sure you have unplugged the correct module, check to see that the window no longer works. If it does not work, proceed to step 2.
Last edited by GaryDoug; Aug 30, 2014 at 01:10 PM.
Thread
Thread Starter
Forum
Replies
Last Post
