Hello everyone,

My question today is about my window crank. When I bought the car the crank was removed and they were using vise grips to lower and raise the window. As you can all probably guess, this led to the stripping of the grooves where the window crank would normally go. Now, I am trying to find the easiest/ most effective way to put it all back together how it is supposed to go. Any information will greatly be appreciated.

 

Shop around and get a new regulator.

http://www.carpartsdiscount.com/auto...ml?3593=127095

http://www.restorationperformance.co...-Window/Detail

http://cgi.ebay.com/ebaymotors/70-71...QQcmdZViewItem

http://cgi.ebay.com/ebaymotors/73-74...QQcmdZViewItem

http://cgi.ebay.com/ebaymotors/70-71...QQcmdZViewItem

 

Thanks for your quick reply. So I do need the whole regulator? I thought I might be able to get off just getting something smaller and cheaper or by rigging something together...

Once again, thanks.

 

Which side do you need? I have an extra regulator you can have, just pay the shipping.

 

I need the driver side.

 

i get a new one. mine did the same thing and the whole thing squeeks and grinds and just wore out. whats better than new(ish) goodies for your Fbody? lol

 

I have a driver's side regulator. I can get some pics of it if you want. It works great, I can check it over real good and lube the gear and friction spring for you. PM me if you want to get it. Anything else you need? I have a lot of small parts left over.