Alright so I'm going to try and get him to lower it but will it not bolt up right away on to the edelbriock performer intake??

 

Oh, you have a Performer intake? Yeah, that'll work.

 

Okay I was looking at another carb also which is more in my price range!! What do I look for to make sure it's a good working carb is there any way or does it have to be hooked up??
edelbrock 750 cfm carb

 

Too big for a stock 350. You'd have to have a big cam, much better heads and plan on reving over 6000 rpm to use that much flow on a 350. I think you'd be very disappointed and it would be very hard to get it to run well. A carb in the 600 to 670 cfm range would be much better suited. I'd keep looking. I picked up an almost new 600 cfm Holley of local CL for $100 which I'll use until I get my 383 built up, then I'll switch to a 750 cfm Holley.

 

Alright thanks

 

If you're still looking for a carb, Edelbrock 1406 600cfm Carburetor here is one in the DFW area. For a stock 350 and your intake, it should be rebuildable/slap on job.

Took a closer look.. it looks like its missing parts on the side, but idk..