Putting an aftermarket tach in and was wondering where to splice in for the tach signal? anybody got any ideas? Thanks in advance.

Sam

 

The - on the coil. I think the signal wire is usualy white.

 

This would normally be the case, but your car has DIS ignition with no distributor and 3 coil packs with no exposed leads. There is a white wire, pin C, on the large connector on the ignition control module (under the coil packs) which carries the tach signal, you can try tapping into it & see if the tach works.

 

OOPS I should have read the thread title.

 

Thanks for the help guys, I'll try it and see what I come up with.