supercharger for 95 camaro?
#11
Hell keep checking out that thread and you can see the right M90 is held up with a block of wood and then later the whole nose of the car is cut off. He can make CAD drawings and the drawings look sound now he needs to work on the fab skills
Massey
Massey
#12
Join Date: Nov 2007
Location: Eastern PA,
Posts: 10,465
I would like to get a hold of those LT1 cad models. All I have is old school V8s. You notice that the pics where over a year old and that is not wood. The angle iron is rusted that bad. His brake master cylinder is almost inside the right supercharge with the power booster already removed. No way is his plumbing design going to work.
This project falls under "never going to be finished" unless he heads back to the drawing board. He should just get the left one working
BTW I thought someone did make a supercharger for a LT1? You can get turbo kits for them.
From "the google" 4 bills and your good to go.
http://dagostinoracing.com/index.php...0¤cy=USD
This project falls under "never going to be finished" unless he heads back to the drawing board. He should just get the left one working
BTW I thought someone did make a supercharger for a LT1? You can get turbo kits for them.
From "the google" 4 bills and your good to go.
http://dagostinoracing.com/index.php...0¤cy=USD
Last edited by Gorn; 11-08-2010 at 11:23 AM.
#13
That is not an LT1 engine!! Look at the distributor it is in the back. That is a Corvette engine that was used right after the TPI and before the LT1 came out.
There is a pic of the engine from below the SC that looks like a piece of oak is shimming it up to be level.
Massey
There is a pic of the engine from below the SC that looks like a piece of oak is shimming it up to be level.
Massey
Thread
Thread Starter
Forum
Replies
Last Post