Big boy time!
#1
Big boy time!
I purchased a late drag car this week for 300 Dallors. Guy had 383 in it and a 700r. He kept motor and tranny but rest of car is there, I have a Jimi Knix built 454 dynoed at 850 hp I bought a while ago with a turbo 400 tranny. I'm planning on putting it in my 84 camero, what all would I need to do to my front suspension to not bind under that much HP? Any Frame connectors or anything of that sort?
#2
wow... where to start...
i'd upgrade to an aftermarket k-member, a-arms, springs, shocks, etc
weld in subframe connectors, new drive shaft, rear diff, 31 spline axles, rear disk brake conversion
is it a t-top car? rollcage installed since it was a drag car? the above is just assuming non of that is already done
i'd upgrade to an aftermarket k-member, a-arms, springs, shocks, etc
weld in subframe connectors, new drive shaft, rear diff, 31 spline axles, rear disk brake conversion
is it a t-top car? rollcage installed since it was a drag car? the above is just assuming non of that is already done
Thread
Thread Starter
Forum
Replies
Last Post
adamgh81
New Members Area
2
03-03-2010 09:46 PM