Old Problem Resurfaces

Thread Tools
 
Search this Thread
 
Old Dec 21, 2007 | 02:42 PM
  #1  
jdubs1813's Avatar
Thread Starter
|
1st Gear Member
Joined: Jan 2007
Posts: 129
From:
Default Old Problem Resurfaces

Well I had posted a while back about my car not cranking at all when I turn the key and a few ideas were thrown out such as the security system, bad solenoid, and a few others. Well I replaced the starter and the ignition cylinder and had not had any problems since then... until today.

Me and a buddy are driving around, park and shut off the car, come back five minutes later, try to crank it and I get nothing. I heard a noise coming from the general region of the starter that sounded like it tried to crank, but seized up or something. I would let go of the key, try again, and hear a noise that sounded like it was trying to turn but couldn't. I didn't get a clicking or anything, just complete silence after that. Any ideas of what this could be? I was thinking my starter could seize up from too much heat from the engine and just had to cool down. So I was thinking about getting heat shield for the starter. Any suggestions?

PS: We pushed the car start and it ran fine. It's amanual 1989 Camaro.
 
Old Dec 21, 2007 | 04:12 PM
  #2  
350rs's Avatar
March 2008 ROTM
Joined: Apr 2006
Posts: 2,437
From: St. Louis, Missouri
Default RE: Old Problem Resurfaces

check your clutch safety switch.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
IROCYOURVTEC
82-92 V6 Tech
5
Oct 20, 2010 01:01 AM
Beest
93-02 V6 Tech
7
Jun 27, 2010 02:42 AM
IZZY1967RS
67-69 General
0
Jun 15, 2008 11:11 PM
2lucke4u
General Tech
4
Sep 1, 2006 09:55 PM




All times are GMT -5. The time now is 02:05 PM.