84 camaro
I really need some help. I have a 1984 berlinetta camaro. I have had to replace my transmission and my flywheel. After i replaced them i havent been able to get my car started. So then i by passed my ecu and still got nothing. then i replaced my distrubuter cap and my rotor. I also replaced my coil on top of the distrubter and still. I had my starter tested and it was fine. And i still have not been able to get my car started back up if ne one could help me i would really appreciate it cause this is my only vehicle and my parent wont by me a new one. So if u come up with ne thing please email me at kellycagle07@hotmail.com. Thank u
ORIGINAL: cagle07
I have had to replace my transmission and my flywheel. After i replaced them i havent been able to get my car started.
I have had to replace my transmission and my flywheel. After i replaced them i havent been able to get my car started.
If its getting spark then its getting voltage to the coil so dont worry about that. You have just about all you need for it to run. Did you happen to unplug any wires? The ones to the module in the distributer? Maybe they got pinched and cut. The tan wire that needs to be unpluged to set the timing?
also when we checked to see if the car was getting fire we took one of the spark plug wires off the engine and stuck and wire in it and stuck the end of it to a screw it arched but the arch wasnt blue it was yellowish color and usually when u get a good arch i no that it is usually blue.


