New project 75 lt 350 zz3 4spd car
#1
New project 75 lt 350 zz3 4spd car
HEY GUYS NEW TO THE SITE WANTED TO SHARE MY NEW CAR HERE.
75 CAMARO LT WITH A ZZ3 350 4SPD 3:23 POSI
RUNS GOOD BUT I THINK IT NEEDS A CLUTCH DISK UNLESS I;M ADJUSTING IT WRONG GRABS LOW TO THE FLOOR. AND WHEN I MAKE IT GRAB HIGHER IT SLIPS EVEN MORE.
CHECK OUT A FEW PICS
http://img375.imageshack.us/img375/7162/dscn0762w.jpg
http://img180.imageshack.us/img180/2941/dscn0773a.jpg
Uploaded with ImageShack.us
75 CAMARO LT WITH A ZZ3 350 4SPD 3:23 POSI
RUNS GOOD BUT I THINK IT NEEDS A CLUTCH DISK UNLESS I;M ADJUSTING IT WRONG GRABS LOW TO THE FLOOR. AND WHEN I MAKE IT GRAB HIGHER IT SLIPS EVEN MORE.
CHECK OUT A FEW PICS
http://img375.imageshack.us/img375/7162/dscn0762w.jpg
http://img180.imageshack.us/img180/2941/dscn0773a.jpg
Uploaded with ImageShack.us
#4
Looks good, a couple of new rockers and a few other patches and you will be ready for the show circuit!! ok well maybe a little more work but still a nice car. Looks like you have a newer engine or at least center bolt style heads.
Massey
Massey
#5
Thanks yeah it has a zz3 crate motor with angle plug aluminum heads. 345 hp not sure it needs the big carb and electric fuel pump thou.
#9
it's all good
tonight i felt like working on the car alittle.
Someone messed the 4spd tunnel alittle and cut two 4 inch cuts to get to the nut on the side of the shifter duh.
So i riveted them closed with 1-1- 1/2 piece of sheet metal.
I dont have a welder or i would have just gave it a few tacks. but alittle seem sealer and i will be ready for the carpet.
also fixed the light on my fuel gauge and oil pressure gauge.
next i got the heater to work loose connection and the parking brake did'nt work because of a weak spring on the mechanizim. i'm sure that was spelled wrong. well enough for tonight, took it for a spin adjusted the clutch again still slips a bit.
tonight i felt like working on the car alittle.
Someone messed the 4spd tunnel alittle and cut two 4 inch cuts to get to the nut on the side of the shifter duh.
So i riveted them closed with 1-1- 1/2 piece of sheet metal.
I dont have a welder or i would have just gave it a few tacks. but alittle seem sealer and i will be ready for the carpet.
also fixed the light on my fuel gauge and oil pressure gauge.
next i got the heater to work loose connection and the parking brake did'nt work because of a weak spring on the mechanizim. i'm sure that was spelled wrong. well enough for tonight, took it for a spin adjusted the clutch again still slips a bit.
Last edited by 75CAMAROLT; 09-29-2010 at 11:25 PM.