new to the program
#41
05-13-2010, 06:11 PM
#42
05-13-2010, 09:15 PM
It's not a bonus if you have to bore it to take the taper out of it or clean up the walls. Hoping for the best for you.
#43
05-13-2010, 09:38 PM
Join Date: Aug 2008
Location: Portland, Or
Posts: 9,097
Yep! If the bore is great and just needs honing then the .030" over is fine, but if it's worn and needs another overbore you're looking at overheating issues when you start boring the cylinder walls too thin! I hope it's just fine as is!
Thread
Thread Starter
Forum
Replies
Last Post