Time for some new sheetmetal on my '69
1st Gear Member
Joined: Dec 2007
Posts: 297
From:
RE: Time for some new sheetmetal on my '69
ORIGINAL: jonnyNITRO
Here's a few picts of the tools I mentioned. The shears were $30 and the steel brush was $1 at Kmart. It lasts quite a while too. I was surprised. I figured that for a dollar, it would fall apart the first day so I bought about 10 of them.
[IMG]local://upfiles/7269/F821074BB48043FC9B64CF3220EE2C36.jpg[/IMG]
[IMG]local://upfiles/7269/AFE32818AE634F9BB5C2FE73E35F9E8D.jpg[/IMG]
Here's a few picts of the tools I mentioned. The shears were $30 and the steel brush was $1 at Kmart. It lasts quite a while too. I was surprised. I figured that for a dollar, it would fall apart the first day so I bought about 10 of them.
[IMG]local://upfiles/7269/F821074BB48043FC9B64CF3220EE2C36.jpg[/IMG]
[IMG]local://upfiles/7269/AFE32818AE634F9BB5C2FE73E35F9E8D.jpg[/IMG]
Thread Starter
|
1st Gear Member
Joined: Mar 2007
Posts: 247
From:
RE: Time for some new sheetmetal on my '69
I'm back !
I have been swamped with work and kid' sports. Plus I am writing the follow-up book for the Wikker series. All in all, it's been good, cause I need the money but, I'm ready to get back to the sheet metal.
Looking to pull the 'ol coupe out of the garage and post some new picts.
Gotta run!
I have been swamped with work and kid' sports. Plus I am writing the follow-up book for the Wikker series. All in all, it's been good, cause I need the money but, I'm ready to get back to the sheet metal.
Looking to pull the 'ol coupe out of the garage and post some new picts.
Gotta run!
Thread Starter
|
1st Gear Member
Joined: Mar 2007
Posts: 247
From:
RE: Time for some new sheetmetal on my '69
I started putting the motor back together. Still a long way to go but the major components are in and I have to start shopping for sensors and figure out the wiring.
[IMG]local://upfiles/7269/5284C792006848E792EB8159A7E45FAE.jpg[/IMG]
[IMG]local://upfiles/7269/5284C792006848E792EB8159A7E45FAE.jpg[/IMG]
Thread
Thread Starter
Forum
Replies
Last Post
adamgh81
New Members Area
2
Mar 3, 2010 09:46 PM
Maynard
93-02 General
47
Feb 27, 2008 09:58 PM
