Finally going to start a restoration on my 68 Camaro and I'm looking for help finding a good supplier for sheet metal....fenders, quarters, floor pans in the Michigan area.

Quality is more important than price....but always looking for a good deal!

Any one you guys would recommend?

 

If quality is more important then you should look for NOS sheetmetal. Aftermarket sheetmetal does not fit right without lots of fabrication, I know, I did almost my whole car. Sheetmetal all comes from the same place Goodmark and Dynacorn so it doesnt matter where you get it some suppliers mark it up and call it premium quality. Be prepared to pay big for NOS and there is a reason for it as I just explained.

 

I recommend checking out classic industries. They are based out of California though.

 

Thanks....I'll check them out!

 

I have had good luck with rapid auto parts too. Worth a look, I've found pretty inexpensive sheet metal through them.