I have rebuilt my windshield frame on my 67 unfortunately when I removed the molding studs I didn't mark where they were. Anybody have the measurements I can use.

 

My 68 convertible currently has nothing in the frame. Is there any measurements you need. There is a difference in measurement between the coupe and convertible.

 

yes I'm looking for the spacing and location measurements in between the trim clip studs. I'm guessing the conv has a different pattern tho?

 

I'm in the middle of doing mine. Here's the photo I took for my reference. The first 1.75" from the corner, then 7.5" every stud after that. The fourth stud is in the center.

 

thanks for the info, rookie mistake on my part. For some reason I cant open the pic says I don't have permission.

 

Do you also have the measurements for the windshield clips that are on the bottom?

 

Two things, if you have the old mouldings the marks will be on them. The other is it does not really matter the mouldings should acccept the clips reagrdless. Just don't put the new studs too close the the end, leave a couple of inches.