Well, I did a very stupid thing a couple weeks back. Long story short, I ended up having to get the entire rear end replaced, two rims and tires also done, which set me back to the tune of $2300... Now I find out my crossmember is bent to the point that NTB can't do a wheel alignment. What's the best bet here? Should I get the part and do it myself or should I take to a frame shop? I'm pretty much broke here. Any help would be great.

 

well id take it to a frame shop,but if youre broke its really all up to you

 

You could try a frame/collision shop, or replace it. However; if the bodywork is also bent, then the bolt holes won't line up.

 

I think I may take it a frame shop so they can determine if the frame is bent too. I looked at the cross member and I can see at least one place where it is bent (A long shallow dimple towards the passenger side). I also replaced the lower control arm on the passenger side which was pretty twerked.

Thanks for the input guys. I"ll update the thread when I have a resolution.