RE: M/T Valve covers...
#1
RE: M/T Valve covers...
I guess this section of the forums is as good as any to ask!
During a recent clean out of the shed I came across a pair of small block Mickey Thompson finned aluminum valve covers. The have the usual M/T logo but no breather holes. I assume, along with the "327" designation inside the valve covers, that these are early small block. My question: Is there any demand for these? The garden variety "with" holes are a dime-a-dozen on eBay. These may be as well. Are these destined for auction or the trash can?
During a recent clean out of the shed I came across a pair of small block Mickey Thompson finned aluminum valve covers. The have the usual M/T logo but no breather holes. I assume, along with the "327" designation inside the valve covers, that these are early small block. My question: Is there any demand for these? The garden variety "with" holes are a dime-a-dozen on eBay. These may be as well. Are these destined for auction or the trash can?
#2
RE: M/T Valve covers...
check e-bay and see if there are any on there, your right they are for pre 68 which had the oil fill tube in the intake and PCV valve in the tube and the air inlet in the back of the block.
#3
RE: M/T Valve covers...
if you still have them, let me know. I have an old intake that I could use with those. My email is mttvogt@gmail.com
Thanks for the help.
Thanks for the help.
Thread
Thread Starter
Forum
Replies
Last Post