MKCoconuts Z28 Project
#222
Got the tune in today
http://vid1104.photobucket.com/album...psvwxd8opi.mp4
Tomorrow I pick up the paint and we start final prep. Once that's done, I'm gonna run it up and down the road to make sure all is good. Get alignment as well. Goal is to have the plates on it by May 23 so I can take it to my nephews birthday. Little guy is turning 1!
http://vid1104.photobucket.com/album...psvwxd8opi.mp4
Tomorrow I pick up the paint and we start final prep. Once that's done, I'm gonna run it up and down the road to make sure all is good. Get alignment as well. Goal is to have the plates on it by May 23 so I can take it to my nephews birthday. Little guy is turning 1!
#225
i have done that so many times and when i reset them on the run there is always one thats off. open headers might make that a little difficult. lol. never done the aluminum ones, you set using the spin push rod
#226
Yeah, once the full exhaust is back on, I might play with them some more. We did it by spinning the pushrod. I'll check them again once there's some mileage on the engine. The most it's seen is going 30 feet out the garage. Once my friend welds the one valve cover so it'll clear the alternator, it'll be set to drive.
#230
All it needs now is the lights put back on, lower bumper covers on, and the interior back together. Should be good to drive soon