I bought a 1995 Z28. It has had a ton of work dumped into the engine, cam, ported heads, new exhaust ect. It had some front end damage from the photo before I made the purchase that looked like just minor cosmetic damage so I bough it. When it got delivered and I got the bumper off I saw that the mount for the bumper; the front extension outside the engine bay, was bent. It is not a huge bend but I am considering my options before I jump in. The three things I'm considering are to either try to bend it out cold till it is close and leave it as good enough, heat the metal then try to bent it out, or cut the chunk off right at where it goes past the rad and weld a new one on off a parts car. I will attach a photo can someone take a look and give me an opinion as to the best course of action.