Over the weekend i tore my lt1 down again to replace a bad front oil seal. I went ahead and replaced the opti agian (free under warranty form zone) It started up and ran fine for about 10min then died. No spark at the coil now. Both the coil and the module are brand new.. Any ideas guys??? Maybe defective opti ?? Or bad computer??

 

ok first things first what yr and model is it? on to the ??? have u been able to scann it? have u checked all the fuses? should be an ignition fuse. are u getting a security light? any other lights?

 

ok its a 95 camaro , its not a fuse issue ive checked them like ten times, no check engine or security light either. Every now and again ill get a spark or 2 out of the coil...but most of the time im not getting any

 

oh yea and the last time i had a scanner put on it the machine was saying that it wasnt getting power to the plug

 

should be a pink wire to the coil turn key on see if u have power there.

 

scanner for a '95 needs a power supply(ie;cig lighter)so...you just changed the opti since you had it apart and got a warranty on it even though opti wasnt the issue?might have went out of fry pan/into fire!!lol.if it ran before.....bad front oil seal wont cause no spark/misaligning opti might!!

 

The opti was installed correctly... Theres power at the pink wire

 

go to this thread and most of the way down it will have some attachments from me have a look at them and see if it will help to test.

https://camaroforums.com/forum/93-02-general-41/strange-problem-38868/

 

Does the opti or the computer control spark at the coil?

 

ended up being another junk opti from autozone swapped it n the cars junning fine ill be ordering a msd soon should of the first time around only good thing is zone agreed to pay me labor reimburstment