New Grille?
#1
New Grille?
I own a 97 3.8, I have no body kit at all, but have chrome rims and after market lights. I didn't do any of this work because it was done when I bought it. Anyways do you guys think this grille would look nice? Does anyone here have this grille? I read when I searched the forum that someone had to remove there fog lights to have this fit? Is that true? If you look closely here it shows the fog lights still in place. I don't want this if I have to remove them. I personally like it, but I am asking because sometimes I like something and then I don't a few months later (what was I thinking?) So, I'm asking for a 2nd,3rd,4th etc. opinion.
#2
By the way the part is only $17.95 which is why I am tempted in the first place. Custom-Fit Billet Grille is made from aircraft-grade billet aluminum with a polished finish.
Last edited by Parrish; 09-11-2009 at 07:49 PM. Reason: spell
#4
I actually have this grill on my camaro its a 96 i bought it with the grill on it. the previous owner changed the fog lights out. I do not know if the orignial would fit but from what it looks like they should. ill take a pic in a few and post it.
#6
Thanks guys, for those of you that have it. Is it reversable? I found these dircetions.
The part about cutting and drilling scares me.
Reaper I'm looking forward to a pic, thanks ahead of time.
Remove the factory black center bumper insert by bending it upwards from
the bottom and clipping with side cutters the bottom plastic attachment studs.
Bend it another 45 degree up and clip the upper attachment studs and
remove.
Run a line of 1/8" tape around the inside perimeter of the cavity on black it out with semi-gloss black.
Center the grille in the opening and mark and drill with an 1/8" bit for the holes in the four tabs.
(4) Secure with the fasteners provided.
the bottom and clipping with side cutters the bottom plastic attachment studs.
Bend it another 45 degree up and clip the upper attachment studs and
remove.
Run a line of 1/8" tape around the inside perimeter of the cavity on black it out with semi-gloss black.
Center the grille in the opening and mark and drill with an 1/8" bit for the holes in the four tabs.
(4) Secure with the fasteners provided.
The part about cutting and drilling scares me.
Reaper I'm looking forward to a pic, thanks ahead of time.