Help what is this stuff for !!!

Thread Tools
 
Search this Thread
 
Old Nov 28, 2013 | 07:34 PM
  #1  
madmank1's Avatar
Thread Starter
|
Newbie
Joined: Nov 2013
Posts: 23
Default Help what is this stuff for !!!

As i stated in my new members post i ended up with my uncle's Camaro and i have no idea what some of the stuff in it is for i am adding some photos to the post of some stuff im not shure what it does if u guys can help that would be great
 
Attached Thumbnails Help what is this stuff for !!!-20131128_200939.jpg   Help what is this stuff for !!!-20131128_200957.jpg  
Old Nov 28, 2013 | 08:34 PM
  #2  
Gorn's Avatar
Fourth Generation Moderator
October 2009 ROTM
iTrader: (1)
Joined: Nov 2007
Posts: 10,560
From: Eastern PA,
ROTM Winner's Club
Default

A quick search on "the goggle" says it is an add on Nitrous control unit. Your Uncle sold you a car he used to race? Is the Nitrous bottle still in the car?

Looks like it has been discontinued. Venom's site does not even mention it.
http://www.streetperformance.com/par...vcn45-134.html

The Jet ship is just a mod for the PCM. What year is the car?
 

Last edited by Gorn; Nov 28, 2013 at 08:42 PM.
Old Nov 28, 2013 | 08:59 PM
  #3  
madmank1's Avatar
Thread Starter
|
Newbie
Joined: Nov 2013
Posts: 23
Default

my uncle didnt sell me the car he passed away and i ended up with it and yes he raced it . i went to the person who did all the work on the car and he wouldnt speak to me about the car not shure why but he told me to leave and he wouldnt do anywork on the car for me. i took it to another place they went through the car said it was good to go but he told me not to touch the nitrous because he said i would need to rebuild or replace the fuel and nitrous solenoids and check the programing to make shure it was right ??? they replaced the fuel pump with a aeromotive a1000
 

Last edited by madmank1; Nov 28, 2013 at 09:09 PM.
Old Nov 28, 2013 | 09:16 PM
  #4  
camaroteen82's Avatar
1st Gear Member
Joined: Mar 2012
Posts: 174
Default

personally I'd have the nitrous removed. especially if the guy who did all the work on the car doesn't want to talk to you about the car. that'd make me really nervous about your car.

I'm gonna take a guess the first picture is a ignition controller. or just a monitor.
 
Old Nov 28, 2013 | 09:25 PM
  #5  
madmank1's Avatar
Thread Starter
|
Newbie
Joined: Nov 2013
Posts: 23
Default

i plan to have it removed the car is a ton to handle without the nitrous im never gonna race it my aunt told me last time he was at the guys shop he had the transmission switch from an automatic to a z06 tranny and my uncle went to test it an was not happy with sumthing and took the car home and parked it. the dash and center console wasnt even put back together yet it was all in a pile in the back seat there where wires going everywhere thats how i took it to the place i went the put it all back together and told me to drive the car for a while and see how it acted if any leakes came about cause it sat so long
 
Old Nov 29, 2013 | 07:43 AM
  #6  
Gorn's Avatar
Fourth Generation Moderator
October 2009 ROTM
iTrader: (1)
Joined: Nov 2007
Posts: 10,560
From: Eastern PA,
ROTM Winner's Club
Default

I think you may have some bad information. I am not a Vet expert but the Z06 transmission is mounted in the back at the rear axle. Unless your back seat is gone and the floor was cut out and the whole rear was switched to a Vett rear you do not have a Z06 transmission.

Is it still an automatic? It is more likely he had some of the Z06 stronger parts installed in the Camaro trans.
 
Old Nov 29, 2013 | 08:43 AM
  #7  
craby's Avatar
April 2011 ROTM
Joined: Mar 2009
Posts: 22,007
From: Tokeland, Washington
ROTM Winner's Club
Default

maybe a t56 trans,,,, the op memory could be off a bit.
 
Old Nov 29, 2013 | 08:52 AM
  #8  
Everett#2390's Avatar
4th Gear Member
Joined: Oct 2012
Posts: 2,595
From: Va. Beach, VA
Default

The Scanmaster is a PCM reading device showing different parameters of the engine and its accessories, ie, alternator output.
Go to Scanmaster's website and download its operation manual/instructions.
As said the Venom box is a nitrous controller. The fuel pump was changed out for providing more fuel when the nitrous system is turned on by the controller.
 

Last edited by Everett#2390; Nov 29, 2013 at 08:54 AM.
Old Nov 29, 2013 | 11:29 AM
  #9  
Gorn's Avatar
Fourth Generation Moderator
October 2009 ROTM
iTrader: (1)
Joined: Nov 2007
Posts: 10,560
From: Eastern PA,
ROTM Winner's Club
Default

Originally Posted by craby
maybe a t56 trans,,,, the op memory could be off a bit.
That why I asked if it was still an automatic. Chuck may clue us in but Vet had their own versions of a 6 speed manual tran made in Germany I think up till the LS1. I am not sure there is a bolt in T56 from a Vet for a LT1.
 
Old Nov 29, 2013 | 12:49 PM
  #10  
Camaro 69's Avatar
Senior Moderator
January 2010 ROTM Winner
Joined: Oct 2007
Posts: 18,306
From: The 'Burbs of Chicago
Default

I'm sure the C4 Vette trans is what he means. That 6 speed was a German made ZF6, much better and stronger than the T56.
 



All times are GMT -5. The time now is 12:30 AM.