79 tach problem
#1
03-29-2007, 02:17 AM
79 tach problem
having a tach issue on a 79 z28. when key is set to run position tach moves up to 1 to 1.5k. when started needle comes all the way around to point directly down. whats the solution or possible faulty part.
thanks for any advice
thanks for any advice
#2
03-29-2007, 02:20 AM
RE: 79 tach problem
well your tach goes back to your distributer if it is stock. is it a factory of aftermarket??? if it is stock go to your distributer and check all connections and grounds and what not.
#4
04-02-2007, 02:22 AM
RE: 79 tach problem
Common Problem. Probably either the tach itself or the printed circuit board.
#5
04-02-2007, 02:51 AM
RE: 79 tach problem
ORIGINAL: ericlamb
having a tach issue on a 79 z28. when key is set to run position tach moves up to 1 to 1.5k. when started needle comes all the way around to point directly down. whats the solution or possible faulty part.
thanks for any advice
having a tach issue on a 79 z28. when key is set to run position tach moves up to 1 to 1.5k. when started needle comes all the way around to point directly down. whats the solution or possible faulty part.
thanks for any advice
Sorry for the slight hijack!
--Jimmy
#6
04-03-2007, 03:14 AM
RE: 79 tach problem
I've had that problem before. You can get a printed circuit board from NPD for 70 some bucks. It's typically that and not the tach itself.
Thread
Thread Starter
Forum
Replies
Last Post
