So About the Spark Plugs..
#1
So About the Spark Plugs..
v6.. v8.. doesnt seem to matter. in the 4th gens its almost IMPOSSIBLE to get to those little guys. i dont have a lift, nor a cherry picker. i have floor jacks and jackstands out the whazoo. with that being said, anybody know of a good way to change plugs and wires?
#3
With stock manifolds, I find it easier to set the front up on jackstands and use a creeper to slide under it and attack them from the bottom, except for the 5.7L passenger side. They are a PITA no matter how you try.
#10
3.4L you can get to them all from the top easy (easy being a relative term with a 4th gen)
LS1 you can get to all but #8 from the top. Drivers side pretty easy, pass side more difficult.
3.8L (older manifold design)Remove the exhaust heat shields for best results. Then only the ones that are hidden behind the manifolds need to be had from underneath. #3 and #4
3.8L (Newer manifolds) all should be accessable from the top
LT1 (^*&^&%&$^%$&*@@$!^$&#) Just leave any hard alcohol or firearms out of reach while attempting this job!
Massey
LS1 you can get to all but #8 from the top. Drivers side pretty easy, pass side more difficult.
3.8L (older manifold design)Remove the exhaust heat shields for best results. Then only the ones that are hidden behind the manifolds need to be had from underneath. #3 and #4
3.8L (Newer manifolds) all should be accessable from the top
LT1 (^*&^&%&$^%$&*@@$!^$&#) Just leave any hard alcohol or firearms out of reach while attempting this job!
Massey