installing a intake
 

Upon installing the headers/ypipe, in the link below, i was considering throwing on a new intake. I've already posted a post about the installing headers but any feedback on how good those headers are would be great. ( http://store.summitracing.com/partde...32&N=700+0 )
My question is when I install this edelbrock tbi intake would I need to buy anything else. (thermostat, housing, anything else?) Also if anybody could give me very brief instructions that would be great thanks a lot. Heres a link to the intake
http://store.summitracing.com/partde...p;autoview=sku

RE: installing a intake
 

all your old stuff should work but do you watn to put old stuff on nice shiney stuff>

RE: installing a intake
 

I don't really care but what old stuff are you talking about?

RE: installing a intake
 

It will be an easy straight forward swap in the intake. Just get the gaskets and a tube of the black RTV silycone:D Use it at the front and rear of the manifold instead of the gaskets. Just put a bead down and also aplly some around the water jackets on the intake gaskets.
I like the Edelbrock exhaust. I had them on my 84 and also installed them on my mom's S10. I have not run the S10 yet down the road but have started it and let it reach operating temps and the TiTec has not burned off anywhere yet.