need seats and door panels

Old Dec 18, 2011 | 02:49 PM
  #11  
bad436z28's Avatar
3rd Gear Member
Joined: Jun 2010
Posts: 804
From: middleville,michigan
Default

theres some good black seats on ebay right now,no reserve,they just need to be dyed.eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices
 
Old Dec 18, 2011 | 03:09 PM
  #12  
bad436z28's Avatar
3rd Gear Member
Joined: Jun 2010
Posts: 804
From: middleville,michigan
Old Dec 18, 2011 | 03:11 PM
  #13  
bad436z28's Avatar
3rd Gear Member
Joined: Jun 2010
Posts: 804
From: middleville,michigan
Default

the cheapest original ones i found are like 350 bucks and dont look very good.
 
Old Dec 18, 2011 | 03:38 PM
  #14  
klong2194's Avatar
Thread Starter
|
In the Staging Lanes
Joined: Aug 2009
Posts: 71
From: Ohio
Default

alright thanks, i found the seats i want, and may just work on my door panels, im not sure yet. I just found out ima have to pull my motor. Im leaking oil from the oil pan.
 
Old Dec 18, 2011 | 08:51 PM
  #15  
bad436z28's Avatar
3rd Gear Member
Joined: Jun 2010
Posts: 804
From: middleville,michigan
Default

u can change ur oil pan gasket without pulling the engine,just lift engine up about 2 inches and ur good,be sure u get the one piece seal so u dont have to worry about it again
 
Old Dec 19, 2011 | 07:01 AM
  #16  
klong2194's Avatar
Thread Starter
|
In the Staging Lanes
Joined: Aug 2009
Posts: 71
From: Ohio
Default

im pulling it just to do it, it will only take an hour, and im wanting to go through everything.
 
Old Dec 19, 2011 | 10:14 AM
  #17  
1971BB427's Avatar
Second Generation Moderator
Feb 2010 ROTM winner
Jan 2013 ROTM winner
Joined: Aug 2008
Posts: 9,097
From: Portland, Or
ROTM Winner's Club
Default

Originally Posted by bad436z28
u can change ur oil pan gasket without pulling the engine,just lift engine up about 2 inches and ur good,be sure u get the one piece seal so u dont have to worry about it again
Never had trouble with a 4 piece myself. Need to make sure the ends are installed properly with silicone gasket adhesive in the corners, and along the two side gaskets. I usually glue it all in place on the block, then install the pan in place.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
germ89
LS Series Tech
3
Nov 6, 2009 09:03 PM
GoofieJ21
93-02 General
3
Jan 13, 2008 09:45 AM
350rs
82-92 General
6
Jan 8, 2008 10:43 PM
L0tuS
82-92 Interior
3
Dec 7, 2005 12:29 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 01:31 PM.